Start with the pattern, then the plate

This setup belongs to our ten-strand flat pattern. It uses a square plate. The eight-strand flat pattern uses a round disk held in a fixed orientation. Keep each setup with its own move sequence.

Keep this orientation

Hold the plate with uppercase E on the left and lowercase e on the right. The top row runs from 1 to 10, left to right. The bottom row runs from 11 to 20, also left to right. Keep the plate facing this way throughout the ten-strand routine; do not rotate it.

10-strand flat braid: starting cord positionsMove cord 3 from slot 5 to lowercase e on the right edge, which should be empty. Keep the other cords in place. Cord numbers identify each strand independently of its color.123142536475869101112131471581691710181920EeCord layout · numbers identify individual cords
Starting arrangement for the ten-strand flat braid. Small numbered circles identify cords; the plate’s numbers identify slots.

Place your ten cords

Tie the cords together at one end and pass the knot through the plate’s center, so the braid can grow below the plate. Place cords 1–6 in top slots 3–8, then cords 7–10 in bottom slots 14–17. Leave all other slots, including E and e, empty.

Starting position for each numbered cord
CordPlate position
Cord 1Top slot 3
Cord 2Top slot 4
Cord 3Top slot 5
Cord 4Top slot 6
Cord 5Top slot 7
Cord 6Top slot 8
Cord 7Bottom slot 14
Cord 8Bottom slot 15
Cord 9Bottom slot 16
Cord 10Bottom slot 17

Match cord numbers before colors: two cords can share a color, but each cord keeps its own number as it moves.

Move, check, advance

The first move takes cord 3 from top slot 5 to lowercase e on the right. The second takes cord 4 from top slot 6 to uppercase E on the left. Follow the complete twelve-move sequence or open the studio for one move at a time.

Check that each destination is empty before moving its cord. If the arrangement differs from the guide, stop and compare positions before continuing.

Set up this braid in the studio

Pause without losing your place

Save your project after a completed move and leave the plate arranged as shown. On returning, match the diagram to your actual cords before continuing. Undo changes the guide only; it cannot undo a physical move.

Try a small sample

Different fibers and tension can change width and appearance. A short sample helps you judge both faces and the finish before using a full set of cut cords.

Instruction reference

The positions and sequence follow Artbeads’ flat kumihimo instructions. The diagram here is original. Kumihimo Patterns is not affiliated with Artbeads.