8 cords / Round structure
Eight-strand round braid
A round-braid starting point for a circular kumihimo disk. Keep the cord pairs and disk orientation aligned with the guide.
Customize this patternMatch these starting cord positions, then follow the move guide in the studio.
Gather your materials
- 8 cords of similar thickness, in colors you can distinguish.
- A round 32-position kumihimo disk with clearly marked positions.
- A way to hold the starting knot, and scissors for finishing.
- Enough spare cord for a practice sample and your chosen finishing method.
Required cord length varies with material, tension and how you finish the ends. Make and measure a short sample before cutting for a finished project.
Keep the setup with the sequence
Match each cord label to its starting position. In the studio, the current move names the position to move from and the position to move to. Work one move at a time, then advance the guide.
If you pause, save the project and leave the cords in their current positions. When you return, compare the setup diagram with your plate before continuing.
Starting setup and moves
Begin with the cord positions shown above. Work through this sequence, then repeat it. Keep your plate or disk aligned with the orientation in the guide.
- Move the lower-left cord into the empty slot immediately to the left of the upper pair.
- Move the upper-right cord into the empty slot immediately to the right of the lower pair.
- Turn the disk clockwise until the next pair of cords is centered at the top. Let the hanging braid turn with the disk.
Instruction references: Artbeads — Kumihimo Getting Started; What a Braid — Kumihimo Tips and Hints
Finish with a sample
Before committing your full project length, check the sample’s width, both faces and tension. Secure the working ends before removing the braid from the plate or disk.